Spin Master AIRHOGS JUMP FURY SERIOUSLY SOFT RC! Manual

BATTERY SAFETY INFORMATION: Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the
battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only
batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries
may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not
recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable-rechargeable
batteries are to be removed from the toy before being charged. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
SPECIAL LiFe BATTERY INSTRUCTIONS: Never charge battery unattended. - Charge battery in an isolated area. Keep away from flammable materials. -
Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating, or igniting. - Do not disassemble, modify, heat, or short-circuit the
batteries. Do not place them in fires or leave them in hot places. - Do not drop or subject to strong impacts. - Do not allow the batteries to get wet. - Only
charge the batteries with the specified Spin Master™ battery charger. - Only use the batteries in the device specified by Spin Master™. - Carefully read the
instruction guide and use the batteries correctly. - In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery. -
Batteries must be recycled or disposed of properly.
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed and non-replaceable. Product disassembly and battery removal must
be performed by an adult. Do not puncture, cut, tear, compress or deform product during disassembly. Ensure product is turned off, then use a screw driver
to remove all screws. Separate product body halves to expose internal electronics. When battery is visible in its entirety, use scissors to cut a single battery
wire, immediately wrap the cut wire end with tape to isolate it, repeat until all battery wires are cut and isolated, and the battery is free from the rest of the
product. Dispose of battery in accordance with your local battery recycling or disposal laws.
FCC STATEMENT: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment
has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that
interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy
off and on while listening for the interference), one or more of the following measures may be useful:
• Reorient or relocate the receiving antenna.
• Increase the separation between the toy and the radio or the TV.
• Consult the dealer or an experienced TV-radio technician for help.
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor,
etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user's
authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To contact the responsible
party please visit fcc.spinmaster.com.
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------
This toy is only to be connected to equipment bearing either of the following symbols:
or
Do not change or modify anything on the toy.
BEFORE FIRST USE: Read the user's information together with your child.
a WARNING: Do not aim at eyes or face.
Spin Master Ltd., 225 King Street West, Toronto ON M5V 3M2 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221
Spin Master International B.V., Kingsfordweg 151, 1043 GR Amsterdam, NL
Spin Master Australia Pty Ltd, Suite 101, Level 1, 18-24 Chandos Street, St Leonards, NSW 2065; 1800 316 982
Spin Master Toys UK Ltd. Secure Trust House, Boston Drive, Bourne End, Buckinghamshire, SL8 5YS, UK
Spin Master logo & © Spin Master Ltd. All rights reserved. Retain this information, addresses and phone numbers for future reference. Content may vary
from pictures. Keep away from obstacles and electrical hazards. Spin Master Ltd. reserves the right to discontinue the www.AIRHOGS.com/JUMPFURY
website at any time.
MADE IN CHINA
For in-depth video instructions go to
AIRHOGS.COM/JUMPFURY
a WARNING: CHOKING HAZARD – Small parts. Not for children under 3 years.
Frequency Band(s): 2.422 – 2.467 GHz
Maximum radio frequency power transmitted: < 10dBm
Spin Master International BV hereby declares that the radio equipment type
JUMP FURY™ is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
http://doc.spinmaster.com
T44648_0001_20130279_GEN_IS_R2
NORTH AMERICA – 1-800-622-8339
customercare@spinmaster.com
UK – 0800 206 1191, serviceuk@spinmaster.com
IRELAND – 1800 992 249
AUSTRALIA –1800 316 982, customercare@spinmaster.com
WWW.SPINMASTER.COM
4
JUMP BUTTON
DRIFT ADJUSTER
JUMP
READY LIGHT BUTTONS
For in-depth video instructions go to
AIRHOGS.COM/JUMPFURY
1 Jump Fury™ 1 Controller
INDOOR USE ONLY
NORTH AMERICA – 1-800-622-8339
customercare@spinmaster.com
CAUTION:
UK – 0800 206 1191, serviceuk@spinmaster.com
!
IRELAND – 1800 992 249
HAIR ENTANGLEMENT —
AUSTRALIA –1800 316 982, customercare@spinmaster.com
Tie back and cover hair and secure
loose clothing prior to play.
WWW.SPINMASTER.COM
POWER
SWITCH
CHARGING
PORT
CHARGING
LED

CONTENTS

1 USB
Charging 1 Instruction
Cable Guide
LOAD JUMP
1 Jumpfury™
INDOOR USE ONLY
! CAUTION:
Tie back and cover hair and secure HAIR ENTANGLEMENT —
loose clothing prior to play.
2
AAA ( LR03 )
x
1.5 V
Not Included
1
4+
YRS
4+ YRS
JUMP TRIGGER
POWER SWITCH
CHARGING
PORT CHARGING
BUTTON DRIFT ADJUSTER BUTTONS LED
CONTENTS
1 Controller 1 USB Charging Cable 1 Sticker Sheet 1 Instruction Guide
NORTH AMERICA – 1-800-622-8339 customercare@spinmaster.com
UK – 0800 206 1191, serviceuk@spinmaster.com IRELAND – 1800 992 249
AUSTRALIA –1800 316 982, customercare@spinmaster.com x 2 AAA (LR03) 1.5 V
WWW.SPINMASTER.COM Not Included
1