Approach Lamp/Mirror Turn Signal Bulb Removal (If Equipped); Approach Lamp Bulb Removal (If Equipped) - Ford 2005 Expedition Owner's Manual

Hide thumbs Also See for 2005 Expedition:
Table of Contents

Advertisement

Lights

Approach lamp/mirror turn signal bulb removal (if equipped)

To change the bulbs:
1. Make sure the headlamp switch is
in the OFF position and then fold
the mirror forward.
2. Remove the torx screw on the
bottom of the turn signal lens using
a T-10 torx driver.
3. Pull the turn signal lens down to
remove it from the mirror assembly.
4. Disconnect the bulb assembly
from the lens.
5. Remove and replace the bulb.
6. Reverse the order to reassemble lamp and lens.

Approach lamp bulb removal (if equipped)

To change the bulbs:
1. Make sure that all the doors are
closed and the interior lights have
automatically turned off or the
opposite mirror approach lamp has
turned off.
2. With a small flat tipped
screwdriver, insert the tip into the
approach light module slot located
on the outboard corner of the lens
to release the clip.
3. While holding the clip in the release position, pull the approach light
module down.
4. Remove the two wires from the module and replace the module with a
new one.
5. Reverse the order to reassemble the approach light module.
113
2005 Expedition (exd)
Owners Guide (post-2002-fmt)
USA (fus)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents