TCL TAC-07CHSA/XA71 Service Manual page 29

10.2 Installation for the first time
Indoor unit
 Install the indoor unit level on a strong wall that
is not subject to vibrations
 The inlet and outlet ports should not be
obstructed: the air should be able to blow all over
the room.
 Do not install the unit near a source of heat,
steam, or flammable gas.
 Install the unit near an electric socket or private
circuit.
 Do not install the unit where it will be exposed
to direct sunlight.
 Install the unit where connection between indoor
and outdoor unit is as easy as possible.
 Install the unit where it is easy to drain the
condensed water.
 Check the machine operation regularly and
leave the necessary spaces as shown in the
picture.
 Install the indoor unit where the filter can be
easily accessible.
OUTDOOR UNIT
 Do not install the outdoor unit near sources of
heat, steam or flammable gas.
Do not install the unit in too windy or dusty

places.
 Do not install the unit where people often
pass. Select a place where the air discharge
and operating sound level will not disturb the
neighbours.
Avoid installing the unit where it will be

exposed to direct sunlight (other wise use a
protection, if necessary, that should not
interfere with the air flow).
 Leave the spaces as shown in the picture for
 The air to circulate freely.
 Install the outdoor unit in a safe and solid place.
If the outdoor unit is subject to vibration, place

rubber gaskets onto the feet of the unit.
Install the indoor unit in the room to be air

conditioning, avoiding to installation in
corridors or communal areas.
Air Conditioner Service Manual
Minimum space to be left (mm) showing in the
picture.
Mounting plate
150mm
condensed water drain pip e
Sleeve
insulatin g covering
electrica l cable
water dra in pipe
150mm
300mm
28