Kohler KD800 Operation page 7

Industrial generator sets, controller: apm802
Hide thumbs Also See for KD800:
Table of Contents

Advertisement

Fuel tanks. Explosive fuel vapors
can cause severe injury or death.
Gasoline and other volatile fuels stored
in day tanks or subbase fuel tanks can
cause an explosion. Store only diesel
fuel in tanks.
Draining the fuel system. Explosive
fuel vapors can cause severe injury
or death. Spilled fuel can cause an
explosion. Use a container to catch fuel
when draining the fuel system. Wipe up
spilled fuel after draining the system.
Hazardous Noise
CAUTION
Hazardous noise.
Can cause hearing loss.
Never operate the generator set
without a muffler or with a faulty
exhaust system.
Engine noise. Hazardous noise can
cause hearing loss. Generator sets
not equipped with sound enclosures
can produce noise levels greater than
105 dBA. Prolonged exposure to noise
levels greater than 85 dBA can cause
permanent hearing loss. Wear hearing
protection when near an operating
generator set.
Hazardous Voltage/
Moving Parts
DANGER
Hazardous voltage. Moving parts.
Will cause severe injury or death.
Operate the generator set only when
all guards and electrical enclosures
are in place.
TP-7070 8/20
WARNING
Hazardous voltage. Backfeed to
the utility system.
Can
cause
property
severe injury, or death.
If the generator set is used for
standby power, install an automatic
transfer switch to prevent inadvertent
interconnection
of
standby
normal sources of supply.
DANGER
Hazardous voltage.
Will cause severe injury or death.
Disconnect all power sources before
opening the enclosure.
Grounding
electrical
Hazardous voltage will cause severe
injury or death.
Electrocution is
possible
whenever
electricity
present. Ensure you comply with all
applicable
codes
and
Electrically ground the generator set,
transfer switch, and related equipment
and electrical circuits. Turn off the main
circuit breakers of all power sources
before servicing the equipment. Never
contact electrical leads or appliances
when standing in water or on wet
ground because these conditions
increase the risk of electrocution.
Installing
the
battery
Hazardous voltage will cause severe
injury or death.
An ungrounded
battery charger may cause electrical
shock. Connect the battery charger
enclosure to the ground of a permanent
wiring system. As an alternative, install
an equipment grounding conductor
with circuit conductors and connect it to
the equipment grounding terminal or
the lead on the battery charger. Install
the battery charger as prescribed in the
equipment manual. Install the battery
charger in compliance with local codes
and ordinances.
Connecting the battery and the
battery charger. Hazardous voltage
will cause severe injury or death.
Reconnect
positive to positive and negative to
negative, to avoid electrical shock and
damage to the battery charger and
battery(ies).
electrician install the battery(ies).
damage,
Short
voltage/current will cause severe
injury or death. Short circuits can
cause bodily injury and/or equipment
damage.
and
connections with tools or jewelry while
making
Remove all jewelry before servicing the
equipment.
Engine block heater.
voltage will cause severe injury or
death. The engine block heater can
cause electrical shock. Remove the
engine block heater plug from the
electrical outlet before working on the
block heater electrical connections.
Electrical backfeed to the utility.
Hazardous backfeed voltage can
cause severe injury or death. Install
a transfer switch in standby power
equipment.
installations to prevent the connection
of standby and other sources of power.
Electrical
is
electrical system can cause severe
injury or death to utility personnel
standards.
working on power lines.
Testing
Hazardous voltage or current will
cause severe injury or death. Have
trained and qualified personnel take
diagnostic
circuits.
equipment with electrically insulated
probes and follow the instructions of the
test equipment manufacturer when
charger.
performing voltage tests. Observe the
following precautions when performing
voltage tests: (1) Remove all jewelry.
(2) Stand on a dry, approved electrically
insulated mat. (3) Do not touch the
enclosure or components inside the
enclosure.
system to operate automatically.
(600 volts and under)
Safety Precautions and Instructions
the
battery
correctly,
Have
a
qualified
circuits.
Hazardous
Do not contact electrical
adjustments
or
repairs.
Hazardous
backfeed
into
a
utility
live
electrical
circuits.
measurements
of
live
Use adequately rated test
(4) Be prepared for the
7

Advertisement

Table of Contents
loading

Table of Contents