Safety Label Locations; Safety Information; Operator Responsibility; Assembly - BBT 9000 Series Owner's Manual

Electric start garden mulcher/chipper
Table of Contents

Advertisement

Safety Label Locations

These labels warn you of potential hazards that can cause serious injury. Read them carefully.

Safety Information

This product is designed to give safe and dependable service if operated according to instructions. Read and
understand this owner's manual before operating your power equipment.

Operator Responsibility

Know how to stop your power equipment quickly in case of emergency. Understand the use of all controls and
connections. Be sure that anyone who operates this power equipment receives proper instruction.
DO NOT let children operate the power equipment.
1. Remove the chipper from its carton.
Cut strapping, remove corner supports including at base of unit, lift the carton to remove.
2. Remove all parts located inside mulching chute and around base of unit.
Ensure all parts are in the chipper carton.
Engine and body (pre-assembled)
Hopper
2 x Wheels
Front Support Leg
Hardware Bag
Handle Bars
Axle
3. Attach the handles
Remove the nut and one washer from each bolt provided with the handles. Insert the handle bolts into the
corresponding holes in the hopper. Secure the handles in place with the washer and nut on the inside of the
hopper. Tighten the nuts using the 13mm spanner provided.
4. Attach the axle
Remove the bolts, washers, spring washers and nuts from inside the axle holes. Line up the holes in the axle
with those in the mulcher base and secure with these nuts, bolts and washers. Tighten nuts using the 13mm
spanner provided.
5. Attach the Wheels
Remove the lock nuts on the axle. When installing wheels, ensure that the tyre inflation valves are on the
outside. Place wheels on axle and secure with lock nut
6. Attach the Front Support Leg
Remove the front support pin and tube. Open the bottom section of the discharge chute fully. Line up the
holes in the front support leg with those in the bottom discharge chute. Re-insert the front support tube and
pin with the bolts to secure the support leg. Tighten.
7. Attach Hopper and discharge chute.
BBT-CH-15
SAFETY INFORMATION

ASSEMBLY

WWW.BBTA.COM.AU
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bbt-ch-15

Table of Contents