Table of Contents
Advertisement
Before Operating the Unit for the First Time
1. Read, understand, and follow all instructions on the machine and in the manual before attempting to
assemble and operate. Keep this manual in a safe place for future and regular reference and for ordering
replacement parts.
2. Make yourself familiar with all controls and their proper operation. Know how to stop the machine and
disengage them quickly.
3. NEVER allow children under 18 years old to operate this machine. Individuals 18 years old and over should
read and understand the operation instructions and safety rules in this manual prior to operation.
4. NEVER allow adults to operate this machine without proper instruction.
5. Keep bystanders, helpers, pets, and children at least 25 metres from the machine while it is in operation.
Stop the machine if anyone enters the area.
6. NEVER run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an
odourless and deadly gas.
7.
DO NOT put hands or feet near rotating parts or in the feeding chambers and discharge opening. Contact
with the rotating impeller can amputate fingers, hands, and feet.
8. NEVER attempt to unclog either the feed intake or discharge opening, remove or empty bag, or inspect and
repair the machine while the engine is running. Shut the engine off and wait until all moving parts have
come to a complete stop. Disconnect the spark plug wire and ground it against the engine.
Preparation
1. Thoroughly inspect the area where the chipper/shredder is to be used. Remove all rocks & foreign objects
which could be picked up or thrown and cause personal injury or damage to the machine.
2. Avoid discharging chipped material out of the discharge chute against a wall or on asphalt, concrete, or
other hard surfaces as material being ejected could ricochet, causing injury to you or bystanders.
3. Always wear protective eye gear during operation or while performing an adjustment or repair.
4. Wear sturdy, rough-soled work shoes and close fitting pants and shirts. Loose fitting clothing or jewellery
can be caught in movable parts. Wear leather work gloves when feeding material in the chipper chute.
5. Before starting the engine, check bolts and screws for proper tightness to be sure the machine is in safe
working condition. Also, visually inspect the chipper/shredder at frequent intervals for any damage.
6. Maintain or replace safety and instruction labels, as necessary.
7.
To avoid personal injury or property damage use extreme care in handling fuel.
a. Use only an approved fuel container.
b. Extinguish all cigarettes, cigars, pipes, and other sources of ignition.
c.
NEVER add fuel to machine indoors.
d. NEVER remove fuel cap or add fuel while the engine is hot or running.
e. Allow engine to cool for at least 2 minutes before refuelling.
f.
NEVER over fill fuel tank. Leave at least 15mm of space below filler neck to provide space for fuel
expansion.
g. Tighten fuel cap securely.
h. If fuel is spilled, wipe it off the engine and equipment. Move machine to another area and wait 5 minutes
before starting the engine.
i.
NEVER store machine or fuel container inside, near an open flame, spark, or pilot light (e.g. furnace,
water heater, space heater, clothes dryer, etc.).
j.
To reduce the fire hazard, keep machine free of grass, leaves, or other debris build- up. Clean up oil or
fuel spills and remove any fuel soaked debris.
k. Allow machine to cool at least 5 minutes before storing.
8. NEVER attempt to make any adjustments while the engine (motor) is running (except where specifically
recommended by the manufacturer).
6
WWW.BBTA.COM.AU
SAFETY INFORMATION
BBT-CH-15
Advertisement
Table of Contents
