Table of Contents
Advertisement
TANKLESS WATER HEATER
Index
1: EH
2: cE
3: In
4: Fu
5: FH
6: FL
7: dr
8: dI
9: HA
10: Cn
11: CI
12: Eh
13: Ct
1:pc
14: vt
2:cp
Table 23 – Installer Mode Descriptions
Toggle through displayed items by turning the dial
To change an item, press the Dial button
Displayed items can be changed by turning the dial
displayed value. To save settings, press the Dial button
To leave Installer Mode, press button B
I. ERROR MODE
When the water heater encounters an error, the display will flash "Er" followed by a numerical code. The wa-
ter heater shall enter a soft lockout condition if the error is such that it can return to normal operation once
the condition relieves itself (overheat conditions, NTC open or shorts, etc.). The water heater shall enter a
hard lockout if the condition indicates something more serious (flame, ignition, condensate line, etc.) To clear a
hard lockout Error Code, press the Power button.
54
Parameter
Default
E0:00
Error History
OFF
Clear Error History
OFF
System Reset
(Factory Setting)
GA
Flow Unit
00
Maximum Fan speed
00
Minimum Fan speed
NO
Reset Burner Operation Time
NO
Reset Ignition Cycle
0 - 2
High Elevation Mode
00
N/A
01
N/A
ON
N/A
N/A
01
N/A
N/A
N/A
N/A
Ten Most Recent Error Codes (H0 – H9)
Restores System to Default Factory Settings
(Burner operation time, Ignition cycles, and Supply power time will not be
Displays Flow Rate in Liters/Minute or Gallons/Minute
Adjusts Maximum Fan Speed Range: -30 - +30
Adjusts Minimum Fan Speed Range: -30 -+30
Select "YES" to Reset Burner Operation Time Range: YES or NO
Select "YES" to Reset Ignition Cycles Range: YES or NO
This water heater may be installed at elevations up to 10,000 feet and operate
on either Natural or LP. The appliance will de-rate by
4% for each 1000 feet above sea level. Select the appropriate installation loca-
Selects Installation Location for Proper Water Heater Operation at
0-2 for installation locations from sea level to 1999 feet
2-5 for locations from 2000 to 4999 feet
5-8 for locations from 5000 to 7999 feet,
8-10 for locations from 8000 to 10000 feet
NOTE: Use a combustion analyzer to ensure CO and CO2 are
within the ranges shown in this manual. Adjust the offset screw in the clockwise
(positive) or counterclockwise (negative) directions (approximately 1/8 turn) if
the measured CO2 value on LOW FIRE is out of range.
.
.
counterclockwise to lower, and clockwise to raise, the
again.
again. The water heater will return to power off mode.
Parameter
Select "ON" to Clear Error History
Range: ON and OFF
reset)
Range: ON or OFF
Range: GA or Li
tion as described below.
Altitude:
Default: 0 – 2
N/A
N/A
N/A
N/A
N/A
N/A
Advertisement
Table of Contents
