Panasonic CS-Z25TKEA Service Manual page 47

12.3.6 Remote Controller Mounting, Installation and Connection
Connector
Remote controller cable
■ Remote control mounting location

Allow sufficient space around the remote
controller 3 as shown in the illustration at right.

Install in a place which is away from direct sunlight
and high humidity.

Install in a flat surface to avoid warping of the
remote controller. If installed to a wall with an
uneven surface, damage to the LCD case or
operation problems may result.

Install in a place where the LCD can be easily
seen for operation. (Standard height from the floor
is 1.2 to 1.5 meters.)

Avoid installing the remote controller cable near
refrigerant pipes or drain pipes, else it will cause
electrical shock or fire.
■ Remote Controller Installation

Remove the remote controller 3 lower case.
(Insert a flat-tipped screw driver or similar tool 2 to
3 mm into one of the gaps at the bottom of the
case, and twist to open. Refer to the illustration at
right.) Be careful not to damage the lower case.

Do not remove the protective tape which is affixed
to the upper case circuit board when remove the
remote controller lower case.

Secure the lower case to an outlet box or wall.
Refer to (A) or (B) instructions below depending
on your choice of cable installation.

Be sure to use only the screws provided.

Do not over tighten the screws, as it may result in
damage to the lower case.
Remote
controller cable
Remote
controller 3
Install the remote controller cable at least 5 cm away from
electric wires of other appliances to avoid miss-operation
(electromagnetic noise).
Upper case
Lower case
Screw
driver
Screws 4 or Screws 5
47
CAUTION
Remote
controller 3
30 mm or more
30 30
Remote
mm mm
controller
or or
more more
lower case
30 mm or more
Upper case
Gaps
Lower case