PCchips M754 Plus Series User Manual page 14

Mainboard User's Manual
1. Locate the Socket-370, JP11 and FAN1. Pull the locking lever
out slightly from the socket and raise it to the upright position.
JP11
B
A
2. On the processor, identify the Pin-1 corner by its beveled edge.
3. On the Socket-370, identify the Pin-1 corner. The Pin-1 corner
is at the end of the locking lever when it is locked.
4. Match the Pin-1 corners and insert the processor into the
socket. No force is required and the processor should drop into
place freely.
5. Swing the locking lever down and hook it under the catch on
the side of the socket. This secures the CPU in the socket.
6. All processors should be installed with a combination heatsink/
cooling fan, connect the cable from the fan to the CPU fan
power connector FAN1.
7. Locate the jumper JP11. Use this jumper to select the CPU
Frequency for the installed CPU. CPU speed is equal to the
CPU Frequency x the CPU Multiplier. The CPU Multiplier
will be detected automatically by BIOS. See the setting list
below.
CPU Frequency Selector: JP11
Frequency 66
JP11-B Short
JP11-A Short
10
Pin-1 Corner
100 105
MHz MHz
Short Open
Open Short
Socket-370
FAN1
133
MHz MHz
Open
Open