Finding A Station - Chevrolet 2006 Corvette Owner's Manual

If your vehicle has the Bose
® ®
Bose AudioPilot noise compensation technology.
When turned on, AudioPilot
audio system to compensate for background noise,
so that your music always sounds the same at the set
volume level. This feature is most effective at lower radio
volume settings where background noise can affect how
well you hear the music being played through your
vehicle's audio system. At higher volume settings, where
the music is much louder than the background noise,
there may be little or no adjustments by AudioPilot
®
To use AudioPilot , set the radio volume to your desired
®
level. Turn AudioPilot on by pressing the automatic
volume button until AVOL ON appears on the display.
As you increase vehicle speed, the background noise in
your vehicle will increase. AudioPilot
audio system's output for the background noise it hears.
®
To turn AudioPilot off, press the automatic volume
button until AVOL OFF appears on the display.
For additional information on AudioPilot
www.bose.com.
MUTE: Press this button to silence the system. Press
this button again to turn the sound on.
This button is not available on the Radio with
Six-Disc CD.
®
audio system, it includes
®
continuously adjusts the
®
.
®
will adjust your
®
, please visit

Finding a Station

BAND: Press this button to switch between FM1, FM2,
AM, or XM1 or XM2 (if equipped). The display will
show the selection.
O
/ e (Tune): Turn this knob to select
radio stations.
t u
SEEK : Press the right or the left arrow to go to
the next or to the previous station and stay there.
The radio will only seek stations with a strong signal
that are in the selected band.
t u
SCAN : Press and hold either arrow for
two seconds until FREQUENCY SCAN appears on the
display. The radio will go to a station, play for a few
seconds, then go on to the next station. Press either
arrow again to stop scanning.
To scan preset stations, press and hold either arrow for
four seconds until PRESET SCAN appears on the
display. The radio will go to the next preset station,
play for a few seconds, then go on to the next preset
station. Press either scan arrow again or one of the
pushbuttons to stop scanning presets.
The radio will only scan stations with a strong signal
that are in the selected band.
3-81