Gate Operator And Canadian Programming - Chevrolet 2006 Corvette Owner's Manual

Hide thumbs Also See for 2006 Corvette:
Table of Contents

Advertisement

6. Locate in the garage, the garage door opener
receiver (motor-head unit). Locate the "Learn"
or "Smart" button. This can usually be found
where the hanging antenna wire is attached
to the motor-head unit.
7. Firmly press and release the "Learn" or "Smart"
button. The name and color of the button may
vary by manufacturer.
You will have 30 seconds to start Step 8.
8. Return to the vehicle. Firmly press and hold the
programmed Universal Home Remote button for
two seconds, then release. Repeat the press/hold/
release sequence a second time, and depending on
the brand of the garage door opener, or other rolling
code device, repeat this sequence a third time to
complete the programming.
The Universal Home Remote should now activate
your rolling-code equipped device.
To program the remaining two Universal Home Remote
buttons, begin with Step 2 of "Programming Universal
Home Remote." You do not want to repeat Step 1, as this
will erase all previous programming from the Universal
Home Remote buttons.
Gate Operator and Canadian
Programming
Canadian radio-frequency laws require transmitter
signals to time out or quit after several seconds of
transmission. This may not be long enough for Universal
Home Remote to pick up the signal during programming.
Similarly, some U.S. gate operators are manufactured
to time out in the same manner.
If you live in Canada, or you are having difficulty
programming a gate operator or garage door opener
by using the "Programming Universal Home Remote"
procedures, regardless of where you live, replace Step 3
under "Programming Universal Home Remote" with the
following:
Continue to press and hold the Universal Home
Remote button while you press and release every
two seconds (cycle) the hand-held transmitter button
until the frequency signal has been successfully accepted
by the Universal Home Remote. The Universal Home
Remote indicator light will flash slowly at first and then
rapidly. Proceed with Step 4 under "Programming
Universal Home Remote" to complete.
2-49

Advertisement

Table of Contents
loading

Table of Contents