NEC MultiSync C750Q User Manual page 15

4. Connect the supplied power cord

WARNINGN:
Please refer to the
AC power cord.


CAUTIONN: Please refer to


NOTEN:
• The monitor should be installed close to an easily accessible power outlet.
• Please make sure that enough power is supplied to the monitor. Please refer to the "Power Supply"
in the specification (See
5. Cable information


CAUTIONN: Use the provided specified cables with this product so as not to interfere with radio and television reception.
For USB, please use a shielded signal cable with ferrite core.
For HDMI, RS-232C and DisplayPort, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
6. Turn on the power for the monitor and the external equipment
Switch on the monitor power first.
7. Operate the attached external equipment
Select the input source for the attached equipment to show the image signal on screen.


NOTEN: Under the conditions below, DDC communication is disabled.
•
Turning off the monitor's main power.
• When [MODE] in [POWER SAVING SETTINGS] has been set to [LOW POWER] in the OSD menu, and the
monitor is turned off or shift to the power saving mode.
8. Adjust the sound
Make volume adjustments when required.
9. Adjust the picture settings (see page 75)
If necessary, make adjustments to the backlight, colors, contrast, and image position in the OSD PICTURE menu.
"Important Information"
"CAUTION 1".
"C750Q" on page 67
Screw
Clamp
English−11
section of this user's manual for proper selection of an
and "C860Q" on page 68).