Settings - Alarm - Alarm - Vivotek ND9441P User Manual

VIVOTEK - Built with Reliability

3-5-9. Settings - Alarm - Alarm

The events reported from individual cameras' digital inputs, digital outputs, and motion detection
can be accommodated in the NVR system's alarm settings. These events will then be reported
or trigger corresponding actions as follows:
1. Reporting events via Email or system buzzer.
2. Triggering video snapshot and text message by the occurrences of events to an FTP site.
3. Triggering the camera(s) for its lens to move to a preset position.
4. Triggering the cameras' digital output.
5. Triggering an event push to VIVOCloud.
You can create up to 10 instances of alarm.
Hardware connections to DIs or DOs, e.g., window sensors, should be made separately. The
motion detection configuration can be made in the Camera configuration window.
When an alarm is triggered, a message prompt
will appear on the Liveview or any configuration
window.
Below is a glimpse of alarm sources and alarm actions:
Sources
Camera/ system DI
Camera/ system DO
Motion detection
Disk full
Disk failure
PIR
Tampering
Camera disconnected
Fan error
82 - User's Manual
Actions
► Video recording
Email
Buzzer
FTP
Camera preset points
Camera DO
Event push to VIVOCloud
* Camera DI/DO, motion detection, and tampering are not
supported for ONVIF cameras.
►video footage
►snapshots
►snapshots
►Pan-Tilt-Zoom