Controller Connection - HIKVISION DS-96000NI-I16 Series Quick Start Manual

Controller Connection

To connect a controller to the NVR:
Disconnect pluggable block from the KB terminal block.
Unfasten stop screws from the KB D+, D- pluggable block, insert signal cables into slots and
fasten stop screws. Ensure signal cables are tightly connected.
Connect Ta on controller to D+ on terminal block and Tb on controller to D- on terminal
block. Fasten stop screws.
Connect pluggable block back into terminal block.
Make sure both the controller and NVR are grounded.
Network Video Recorder Quick Start Guide
Controller Connection
17