Chevrolet 1999 Prizm Owner's Manual page 100

Headlamp High/Low Beam Changer
It will go off when you switch to the low beams. To
switch back to low beams, pull the lever toward you.
Flash-to-Pass
-
With the lever in the low
toward you to momentarily switch to high beams (to
signal that you are going to pass). If you have the
headlamps on when you release the lever, they will
return to the low beams.
2-30
First, you must have the
headlamps on. For high
beams, push the turn signal
lever away from you. When
the high beams are on, this
light on the instrument
panel also will be on.
beam position, pull the lever
Windshield Wiper/Washer Lever
Move the lever to the position you want:
OFF: The wipers are off.
INT: This position provides intermittent windshield
wiper operation. In light rain or snow, you might want to
use this position rather than continuous wiping. You can
change the time between wipes by turning the INT
TIME band. Turn the band forward or rearward for a
longer or shorter delay intervals.
LO: The wipers will run continuously at low speed.
HI: The wipers will run continuously at high speed.
The lever on the right side
of the steering column
controls the windshield
wipers and washer.
yellowblue