Malfunction analysis
Phenomenon
Air conditioner
can't operate
Mist is emitted
from indoor
unit's air outlet
Set
temperature
can't be
adjusted
Cooling
(heating)
effect is
not good.
Check items
● Power failure?
● Earth leakage circuit breaker
trips off or fuse is burnt out?
● Wiring has malfunction?
● Unit has restarted
immediately after stopping
operation?
● Whether the function setting
for remote controller is
correct?
● Indoor temperature and
humidity is high?
● Unit is operating under auto
or save mode?
● Your required temperature
exceeds the set temperature
range?
● Voltage is too low?
● Filter is dirty?
● Set temperature is in proper
range?
● Door and window are open?
● Wait until power recovery.
● Ask professional to replace
earth leakage circuit breaker
or fuse.
● Ask professional to replace it.
● Wait for 3min, and then turn
on the unit again.
● Reset the function.
● Because indoor air is cooled
rapidly. After a while, indoor
temperature and humidity will
decrease and mist will
disappear.
● Temperature can't be
adjusted under auto and save
modes. Please switch the
operation mode if you need to
adjust temperature.
● Set temperature range:
16°C~30°C .
● Wait until the voltage
resumes to normal.
● Clean the filter.
● Adjust temperature to proper
range.
● Close door and window.
29
Solution