Cooling Operation - Hitachi RAC-E25YHAB Manual

COOLING OPERATION

Use the device for cooling when the outdoor temperature is -10 to 46°C.
If humidity is very high (over 80%) indoors, some dew may form on the air outlet grille of the indoor unit.
Right/Left
F.Wash
Sleep Silent
Right/Left
F.Wash
Sleep Silent
Press the MODE selector button so that the display indicates
1
(COOL).
Set the desired FAN SPEED with the
display indicates the setting).
2
Set the desired room temperature with the TEMPERATURE buttons
(the display indicates the setting).
3
The temperature setting and the actual room temperature may vary
somewhat depending on conditions.
Temperature range can be set between 16°C and 32°C.
Press the
beep. Press the button again to stop operation. The cooling function
does not start if the temperature setting is higher than the current
START
room temperature (even though the
STOP
The cooling function will start as soon as you set the temperature
below the current room temperature.
As the settings are stored in memory in the remote controller, you only
have to press the
During AUTO fan, the fan speed automatically changes as below:
When the difference between room temperature and setting tem-
perature is large, fan starts to run at HI speed.
After room temperature reaches the preset temperature, fan speed
will be changed to lower speed to obtain optimum room temperature
condition for natural healthy cooling.
- 10 -
(AUTO) (HIGH)
(SILENT)
(ON/OFF) button. Cooling operation starts with a
(ON/OFF) button next time.
(FAN SPEED) button (the
(MED)
(LOW)
(OPERATION) lamp lights).