After Sales Service And Warranty - Hitachi RAC-E25YHAB Manual

AFTER SALES SERVICE AND WARRANTY

WHEN ASKING FOR SERVICE, CHECK THE FOLLOWING POINTS.
CONDITION
If the remote controller is not
transmitting a signal.
(Remote controller display is
dim or blank.)
When it does not operate.
When it does not cool well.
When it does not heat well.
FROST WASH OPERATION
Frost wash operation
does not start
Noise occurred
during frost wash
operation
(FROST WASH)
indicator blinks
• Do the batteries need replacement?
• Is the polarity of the inserted batteries correct?
• Is the fuse all right?
• Is the voltage extremely high or low?
• Is the circuit breaker "ON"?
• Is the power plug inserted?
• Do you have any power cut?
• Is the air filter blocked with dust?
• Is the set temperature suitable?
• Have horizontal air deflectors been adjusted to their correct
positions according to the operation mode selected?
• Are the air inlets or air outlets of indoor and outdoor units
blocked?
• Is the fan speed " LOW " or " SILENT "?
It does not wash when outside temperature is less than about 1 degrees Celsius or
more than 4 degrees Celsius. 6
It does not wash when the humidity in the room is about 30% or less or about 70% or
more.
When "FROST WASH" is done by operating a remote controller, it does not wash
when the room temperature is less than about 10 degrees Celsius or more than about
32 degrees Celsius.
Within 60 minutes after the end of "FROST WASH", "FROST WASH" is not operated
for product protection.
It is the sound that the internal machine is inflated and contracted by the temperature
change and the fin of the heat exchanger is frozen and thawed
Repeat for 1 second on and 1 second off for 10 seconds
Because "FROST WASH" can not work when operating the "FROST WASH" with
remote controller.
・ The air conditioner is operating
Outside air temperature, room temperature and room humidity are not
・
suitable for "FROST WASH"
・ It has not been over 60 minutes since the end of "FROST WASH"
Repeat for 4 seconds on and 1 second off for 15 seconds
Because it is not "FROST WASH" for a long time.
Operate the remote controller to operate "FROST WASH".
- 21 -
CHECK THE FOLLOWING POINTS