Table of Contents
Advertisement
- 2 Sequence
-P- C049 * # 2 %%%% &&&& ^^ !! %%%% &&&& ^^ !!
# is the port the beep is intended for.
1,2,3 - Store Beeps data at these radio ports
2 indicates that 2 sequence are used
** Sequence #1
%%%% is the frequency counts for the first tone in sequence 1
&&&& is the frequency of the second tone in sequence 1
^^ is the length of the sequence (10mS Steps)
!! is the delay between sequence 1 and sequence 2
** Sequence #2
%%%% is the frequency counts for the first tone in sequence 2
&&&& is the frequency of the second tone in sequence 2
^^ is the length of the sequence (10mS Steps)
!! is the delay between sequence 2 and sequence 3
- 3 Sequence
-P- C049 * # 3 %%%% &&&& ^^ !!
# is the port the beep is intended for.
1,2,3 - Store Beeps data at these radio ports
3 indicates that 3 sequence are used
** Sequence #1
%%%% is the frequency counts for the first tone in the sequence 1
&&&& is the frequency of the second tone in the sequence 1
^^ is the length of the sequence (10mS Steps)
!! is the delay between sequence 1 and sequence 2
** Sequence #2
%%%% is the frequency counts for the first tone in the sequence 2
&&&& is the frequency of the second tone in the sequence 2
^^ is the length of the sequence (10mS Steps)
!! is the delay between sequence 2 and sequence 3
** Sequence #3
%%%% is the frequency counts for the first tone in the sequence 3
&&&& is the frequency of the second tone in the sequence 3
^^ is the length of the sequence (10mS Steps)
!! is the delay between sequence 3 and end of the sequence
Error Messages:
If the format is not correct, the RLC-2 will send a "E" error code.
E1 - Too Many Digits Entered
E2 - Invalid Number of Sequences
E3 - Invalid Port for the Sequences. Must be 1,2,3
Copyright 1995 Link Communications Inc.
67
Advertisement
Table of Contents
