Link RLC-2 Manual page 55

Pass Name: Brief Functional Description
P0 C127 Remote base Store Memory ##
P0 C128 Remote base Start Scan
P0 C129 Remote base Program radio address, Scan features program
P0 C130 Remote base Interrogate last entered frequency
P0 C131 Send DTMF style data down a selected port
P0 C132 Set-up DTMF regeneration length and delay
P0 C133 Clock read time female
P0 C134 Clock read date female
P0 C135 Clock read time male
P0 C136 Clock read Good Morning, Afternoon, Evening
P0 C137 Clock set the time
P0 C138 Clock set the date
P0 C139 Set the CW code speed
P0 C140 Set the CW code frequencies
P0 C141 2-Tone commercial paging program
P0 C142 2-Tone commercial paging recall
P0 C143 Control receiver mode select: COntrol receiver or a receiver port
P0 C144 Control receiver audio routing variable
P0 C145 Software resistors program
P0 C146 Program pre-access words
P0 C147 Configure pre-access on controller
P0 C148 DTMF keypad test
P0 C149 Build and send a voice message
P0 C150 Send ports initial ID
P0 C151 Enable/Disable Analog High/Low time-stamping
P0 C152 Autopatch Go from Direct On-Air to Monitor On-Air Ports
P0 C153 Autopatch Cancel snoop monitoring channels
P0 C154 Autopatch Reverse Patch Answer
P0 C155 Autopatch snoop on Main port
P0 C156 Autopatch snoop on Link 1
P0 C157 Autopatch snoop on Link 2
P0 C158 Autopatch reverse patch log-on
P0 C159 Autopatch reverse patch direct on-air
P0 C160 Autopatch "ON"
P0 C161 Autopatch "OFF"
P0 C162 Autopatch Program Dialing Table Slots
P0 C163 Autopatch Voice Recall Dialing Table Slots
P0 C164 Autopatch Enable/Disable Dialing Table Checking
P0 C165 Autopatch Manual OFF-Hook, Reverse Patch Answer
P0 C166 Not Currently Enabled
P0 C167 Autopatch Memory Dialer Program
P0 C168 Autopatch Memory Dialer Readback
Command Listing (by name)
Copyright 1995 Link Communications Inc.
43