Chevrolet 1993 S-10 Pickup Owner's Manual page 146

Comfort Controls & Audio Systems
Am-St Button
The Am-St is just below the PWR button. Push this when you tune to an
AM station that broadcasts in stereo. Your STEREO light will come on when
you're receiving AM stereo. If you push Am-St and there is no more noise,
it
means the station is weak. You'll hear the station better if you don't use
Am-St. Just push the Am-St button again to delete stereo.
LOUD
The loudness button is next to the PWR button. Push it to get more bass
sound.
D N P
Your audio system has automatic Dynamic Noise Reduction. It helps remove
background hiss noise from the radio or tape player.
DNR@ is a registered trademark of the National Semiconductor Corporation.
To Play A Cassette
Your tape player is built to work best with tapes that are 30 to 45 minutes
long on each side. Tapes longer than that are so thin they may not work well
in this player.
Once the tape is playing, use the upper and lower knobs for volume, balance
and fade, just as you did for radio. The arrows indicate which side of the
tape is being played.
Cr02
The Cr02 button lets you set the system for the type of cassette being used.
If you are using chrome or metal tapes, push the Cr02 button in.
FWD (Forward)
To rapidly advance the tape, press FWD, and the tape will rapidly go forward
until you press the REV button lightly.
REV (Reverse)
To rapidly reverse the tape, press REV, and the tape will rapidly reverse until
you press the W D button lightly.
SEARCH
Push the SEARCH button to the right. (The ON light will come on.)
Push FWD to go to the beginning of the next selection.
Push REV with the SEARCH ON light lit, and the tape will reverse to the
beginning of the current selection.
3-1
8