1. Introduction The base*hazer*pro is a powerful hazer. The machine can be used in many fields of operation and is providing excellent support for lighting effects. 2. Safety Instructions A fog machine is not a toy! 2.1 Risk of getting burnt and general saftey •...
Page 3
The base*hazer*H – special liquid for use in the base*hazer*pro is available in 5-ltr. – and 25-ltr.- bottles and 200-ltr.-barrels. You will find the Material Safety Data Sheet for base*hazer*liquid and Document of Compliance under www.hazebase.com. To guarantee the trouble-free operation of the base*hazer only the special base*H has to be used.
4. Operating the base*hazer*pro From the finest mist to a thick haze any desired effect can be achieved. These haze effects form slowly so that the device should be switched on some time before the lighting or laser will start to operate.
5.3 Operating via DMX 512 Connecting the base*hazer*pro to a DMX desk, use the DMX socket beside the control panel. As soon as the machine receives a correct DMX signal, the yellow DMXLED will be lit. !Please note: The base*hazer*pro uses two channels on your desk! First Channel = Pump, second Channel = Fan.
Page 6
Adjusting the pump and fan output in Stand alone - use a) Press the Mode-button at the control panel until a P and two figures will appear on the LED-display. b) Adjust the desired data (1 - 99%) by pressing the Up- or Down-button c) Press the Mode-button again until an F and two figures will appear on the display d) With the Up- or Down-button the fan data can now be adjusted.
5.7 Use by internal timer With the internal timer, the haze time and wait time can be adjusted in Minutes (0.1 - 99), the pump and fan output can be adjusted in per cent (0 - 99). To start the Timer-Mode, press and hold the Mode button for more than 2 Seconds. The red Timer/Profile-LED will blink as soon as the machine has switched to the Timer-Mode.
7. Troubleshooting Trouble: The pump runs, but little or no haze is produced. Cause: The pump sucks no or too little fluid. Check whether the canister is empty · Check whether the brass collar is properly connected with the brass coupling Check whether the fluid filter in the canister is clogged ·...
9. Warranty conditions For the base*hazer*pro hazebase`s guarantee is: 1. Free of charge, subject to the following conditions (No. 2 - 6) we will repair any defect or fault in the unit if it is caused by a proven factory fault and has been advised immediately after appearance and within 24 month of delivery to the end user.
Need help?
Do you have a question about the base hazer pro and is the answer not in the manual?
Questions and answers