Nozzle Maintenance; Cord Maintenance - Shark UltraLight POWERFINS HZ600 Series Owner's Manual

SELF-CLEANING BRUSHROLL
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, clear them from the
brushroll.
DEBRIS WRAPPED
AROUND BRUSHROLL
Clean off any debris on the brushroll.
To minimize the risk of power cord damage, DO NOT run the vacuum over the power cord.
If this occurs, immediately shut off power to the vacuum and remove the cord from the
brushroll or nozzle.
NOTE: For best performance, keep the Soft Roller clean with regular maintenance.
s h a r kc l e a n . c o m
MAINTENANCE

NOZZLE MAINTENANCE

DEBRIS BEHIND BRUSHROLL
Check the Debris intake and clear away any dirt
or blockages. To close the cover, push down
until it clicks into place.

CORD MAINTENANCE

1.
2.
3.
4.
5.
DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
DO NOT close the door on the cord.
DO NOT pull the cord around sharp
corners.
DO NOT leave the cord near heated
surfaces.