Advertisement
SUBJECT: NIP BAND WIDTH AND TRAILING EDGE SKEW
ADJUSTMENT
2. Trailing Edge Skew Adjustment Procedure
Perform the following procedure in the field to decrease the amount of trailing edge skew:
1) Measure the height of the screw on both fusing unit pressure arms. (The factory
standard specification is described on the previous page.)
2) Change the screw height, making sure of the following:
NOTE: • The skew will be reduced 0.1 mm by turning the screw once.
• The height of the screw will change 0.7 mm by turning once.
• Do not turn the screw more than 3 turns.
If the skew on the copy paper is to the right, turn the left pressure arm screw
clockwise.
If the skew on the copy paper is to the left, turn the right pressure arm screw
clockwise.
Technical Bulletin
No. RTB-001
DATE: Oct. 31 '96
PAGE: 2 of 2
Advertisement
