Cadillac 2000 Escalade Manual page 89

3. Press the LOCK button on the keyless entry
transmitter until you hear the number of chimes that
corresponds to the mode selection you want.
The mode you select is now set. You can either exit the
programming mode by following the instructions later in
this section or program any of the previously mentioned
features on your vehicle.
Leaving Programming Mode
When programming is done, turn the ignition to OFF
and replace fuse 17.
R
Passlock
Your vehicle is equipped with the Passlock
-
theft deterrent system.
Passlock is a passive theft
enables fuel if the ignition lock cylinder is turned with a
valid key. If a correct key is not used or the ignition lock
cylinder is tampered with, fuel is disabled.
-
deterrent system. Passlock
During normal operation, the SECURITY light will go
off approximately five seconds after the key is turned to
the RUN ignition position.
If the engine stalls and the SECURITY light flashes,
wait until the light stops flashing before trying to restart
the engine. Remember to release the key from START
as soon as the engine starts.
If the engine is running and the SECURITY light comes
on, you will be able to restart the engine if you turn the
engine off. However, your Passlock system is not
working properly and must be serviced by your dealer.
Your vehicle is not protected by Passlock at this time.
You may also want to check the fuse (see "Fuses and
Circuit Breakers" in the Index). See your dealer
for service.
In an emergency, call the Cadillac Roadside
-
Assistance Center at 1 800
- -
In Canada, call 1 800 268
- -
882 1112.
-
6800.
2-21