Advertisement
2. INTRODUCTION
robust design with built-in spring loaded telescopic mounting brackets. soft padded hooks provide good protection against bonnet. 36 sMD LEDs
and angled PcB give complete engine bay illumination with 120° spread of light. LED indicators show low charge, charging and fully charged.
foldable design for easy storage when not in use.
3. SPECIFICATION
Model No: .................................................................................. LED036.V2
Battery: ..................................................................... 7.4V 2.0Ah Lithium-ion
Power: .................................................................................................... 7W
Minimum/ Maximum Bonnet Width: .......................................1230/1940mm
Approximate operating time:.............................................................. 3.5 hr
Approximate charging time: .................................................................. 6 hr
4. OPERATION
4.1.
ATTACHING LAMP TO BONNET.
4.1.1. the lamp will need to be charged before each use.
4.1.2. to charge the lamp, use either the in-car charger, or the mains charger. Low charge is indicated by a red lamp, which turns green once
charged.
4.1.3 fold the lamp out straight, tighten the thumbwheel (see fig.2.). Place the padded hook at the end of the lamp, over one edge of the bonnet,
and gently pull the lamp towards the other side of the bonnet.
4.1.4. steady the lamp with one hand, whilst extending the hook over the other side of the bonnet.
4.1.5. to use the lamp, select one of the two brightness settings using the switch on the end of the lamp.
4.1.6. When finished, disconnect the transformer plug from the mains supply, fold up and store the lamp in a safe, dry and childproof
location.
NOTE the lamp will not operate whilst being charged.
5. MAINTENANCE
5.1.
Keep lamp clean and check for damage before every use. If damage is observed, remove from use until unit is repaired.
5.2.
Before the unit is disposed of at the end of its life, it is a requirement that the battery is removed. refer to the battery removal section below.
Environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
remove the 4 screws on the side of the lamp, adjacent to the switch. Pull the casing apart. Pull the hook outwards,
exposing the end plate screw, undo this to release the battery. Dispose of battery according to local government
guidelines.
under the Waste Batteries and Accumulators regulations 2009, Jack sealey Ltd are required to inform potential pur
chasers of products containing batteries (as defined within these regulations), that they are registered with Valpak's
registered compliance scheme. Jack sealey Ltd's Batteries Producer registration number (BPrn) is BPrn00705.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack sealey Limited
Battery Removal
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park,
Bury st. Edmunds, suffolk,
IP32 7Ar
Original Language Version
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the Eu Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.
01284 757500
01284 703534
LED036.V2
www.sealey.co.uk
sales@sealey.co.uk
Issue: 1 - 24/02/14
Advertisement
