Table of Contents
Advertisement
4. Using both hands, press the hand-held transmitter
button and the desired button on the universal
transmitter. Continue to hold both buttons
through Step 5.
light on the universal transmitter flash slowly and
then rapidly. The rapid flashing, which could take up
to 90 seconds, indicates that the universal transmitter
has been programmed. Release both buttons once the
light starts to flash rapidly.
5. Hold down both buttons until you see the indicator
If you have trouble programming the universal
transmitter, make sure that you have followed the
directions exactly as described and that the battery
in the
hand-held transmitter is not dead. If you still cannot
program it, rotate the hand-held transmitter end over end
and
try
again. The universal transmitter may not work
with older garage door openers that do not meet current
Federal Consumer Safety Standards. If you cannot
program the transmitter after repeated attempts, consult
the manufacturer of the unit at 1-800-335-3515.
Be sure to keep the original hand-held transmitter in case
you need to erase and reprogram the universal transmitte
Note to Canadian Owners: During programming, the
hand-held transmitter may stop transmitting after one or
two seconds. If you are programming from one of these
transmitters, you should press and re-press the button on
the hand-held transmitter every two seconds without ever
releasing the button on the universal transmitter. You may
have to repeat this step several times while programming.
Advertisement
Table of Contents
