Table of Contents
Advertisement
7. Connect the power cord to the power outlet.
NOTE:
Please refer to the
8. Turn on the monitor by touching the [ ] key and then turn on the computer (Figure E.1).
9. When using analog (VGA) input, No Touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial
setup. For further adjustments, use the following OSD controls:
• [AUTO CONTRAST]
• [AUTO ADJUST]
Refer to the
Controls
section of this User's Manual for a full description of these OSD controls.
NOTE:
If you have any problems, please refer to the
Adjustable stand with pivot capability
Raise and Lower: Hold the monitor screen on each side and lift or lower to the desired height.
Tilt and Swivel: Hold the top and bottom sides of the monitor screen with your hands and adjust the tilt and swivel as desired.
Screen Rotation (Pivot): Hold each side of the monitor screen, lift to its maximum height and tilt to its maximum tilt angle, then
rotate the screen from landscape to portrait.
You can adjust the OSD (On-Screen Display) menu rotation to match the screen rotation. Refer to the [OSD ROTATION]
instructions (see
page
18).
Rotation, Raise and Lower
CAUTION: Handle with care when adjusting the monitor screen. Do not apply pressure to the LCD when adjusting the
height and rotating the monitor screen.
Before rotating, disconnect the power cord and all cables from the display. The screen must be raised to the
highest level and adjusted to maximum tilt to avoid knocking the screen on the desk or pinching your fingers.
CAUTION
section of this manual for proper selection of the AC power cord.
Troubleshooting
Figure E.1
English-8
section of this User's Manual.
Power key
Tilt and Swivel
Advertisement
Table of Contents
