4
Reconnect all 5-inch internal device cable connections.
5
Reconnect all operator panel cable connections.
8
Attaching the side cover
Perform the removal procedure in reverse to attach the side cover to the server. Refer to "6
Removing the side cover" (pg 11) for details.
9
Converting to a rackmount model
Perform the following steps to attach the rack conversion kit to the server:
1
Attach the handle.
Fasten the handle at the front of the
server by the 2 screws (M3) pro-
vided.
14
Conversion procedure
Use the floppy disk power cable for both the floppy disk drive
and the CD-ROM device.The connector for the CD-ROM is
located midpoint along the power cable.
•
Do not remove the wrist grounding strap until the side cover
installation is complete.
•
Before replacing the right side cover, check to see whether
any tools were left inside the server.
Handle orientation
Ledge is
right side
[Left]
[Right]