Buick 2007 LaCrosse Owner's Manual page 108

It is possible for the PASS-Key
accept the transponder value of a new or
replacement key. Up to 10 keys may be
programmed for the vehicle. The following
procedure is for programming additional keys only.
If all the programmed keys are lost or do not
operate, see your dealer or a locksmith who can
®
service PASS-Key III to have keys made and
programmed to the system.
To program the new key do the following:
1. Verify that the new key has PK3 stamped
on it.
2. Insert the master key in the ignition and start
the engine. If the engine will not start, see
your dealer for service.
3. After the engine has started, turn the key to
OFF, and remove the key.
4. Insert the key to be programmed and turn it to
RUN within five seconds of removing the
original key.
108
®
III decoder to 5. The SERVICE THEFT SYSTEM warning
message on the DIC will turn off, once the
key has been programmed. It may not
be apparent that the SERVICE THEFT
SYSTEM warning message went on due to
how quickly the key is programmed.
6. Repeat Steps 1 through 5 if additional keys
are to be programmed.
If the SERVICE THEFT SYSTEM warning
message appears and stays on the DIC while the
vehicle is being driven, the engine will be able
to be restarted if it is turned off. Your
®
PASS-Key III system, however, is not working
properly and must be serviced by your dealer.
The vehicle is not protected by the PASS-Key
system at this time.
®
If the PASS-Key III key is lost or stolen, see your
dealer or a locksmith who can service
®
PASS-Key III to have a new key made.
®
III