Advertisement
Electric Floor Model Braising Pan with Manual Gearbox Tilt
Electrical Connections
Electrical and grounding connections must comply with the applicable portions of the National Electrical
Code and/or other local codes.
Before performing any maintenance disconnect the electrical power supply and place a tag at the disconnect
switch to indicate that you are working on the circuit.
The wiring compartment is located behind the control panel. Refer to Page 4 Service Connections.
1. Remove the wiring compartment cover and make electrical connections per the wiring diagram located inside the
control housing cover panel. (The braising pan must be grounded in accordance with requirements of the National
Electrical Code or applicable local codes.) (See Electrical Grounding Warning above). Connection from incoming lines
must be waterproof.
2. To access the wiring compartment: remove the tilt handle, loosen hinge screws (about 1/2") at the bottom of
compartment and pull down the front control panel.
3. Ground skillet to terminal provided in control housing. A wiring diagram is provided and is located inside the control
cover panel.
4. Replace wiring compartment cover.
Service Connections
All internal wiring for the skillet is complete.
Make service connections as indicated. (See Service Connections and Installation Instructions Sections in this manual.)
If a faucet is provided, connect the water supplies and check for proper operation.
INSTALLATION & OPERATION MANUAL 10154 REV 0 (05/21)
WARNING
ELECTRICAL GROUNDING INSTRUCTIONS
WARNING
I
NSTALLATION
7
PAGE
OF16
Advertisement
