Table of Contents
Advertisement
Chapter 2 Installation Instructions
Section 1 Installation of Horizontal Display
Refer to the Fig.,
①
the magnetic buckle off
firstly,
fold and attach
②
the rubber side of the
magnetic buckle
on
mental
plate. Adjust the
position of the magnet
buckle to change the
viewing angles.
As the fig. below, rotate aside the Cover Locks firstly, and take the monitor out.
Then turn the monitor's backside to the Protective Cover:
half of the monitor into the Protective Cover, and
monitor into the Protective Cover. Rotate down the Cover Locks to prevent the
monitor from sliding out.
As the fig. , connect On-Lap 1102 to
a laptop. On-Lap 1102 can be pow-
ered on through two USB ports or a
5V-2A adapter. The video input
source is "HDMI1".
P.S. If the monitor does not get enough power from a single USB port, it
may cause splash screen or display interruption. Please connect to two
USB ports on your PC or the 5V-2A adapter.
take
①
the
display is 40 degrees. Do not attach the
magnetic buckle higher than the
otherwise it may cause the monitor over-
turning.
②
The min. viewing angle of horizontal
Put the top half of the
②
blue line
Put the bottom
①
3
,
Advertisement
Table of Contents
