Table of Contents
Advertisement
Power Management
Power Management
Programs for power management can change the settings for the energy saving functions.
Power Management
Power Management Mode .............. [Enabled ]
IDE Hard Disk Standby Timer
System Sleep Timer
Sleep Mode
Power Switch < 4 Sec. ............... [Power Off ]
System Wake-Up Event
Modem Ring Indicator .............. [Disabled ]
Magic Packet ..
↑↓ = Move Highlight Bar
Esc = Exit
Example for menu Power Management
Power Management Mode
This field defines the extent of the energy saving functions. When Enabled is set, the functions set in
the fields IDE Hard Disk Standby Timer and System Sleep Timer are effective. When Disabled is set, the
energy saving functions are disabled.
Power Switch < 4 sec
Power Off switches the system off, when the On/Off switch is pressed.
Suspend switches the system in Suspend mode, when the On/Off switch is pressed.
System Wake-Up Event
specifies the event which wakes up the system.
Modem Ring Indicator
specifies whether the system can be switched on by an incoming message (e.g. via modem, fax or
telephone). The signal can be supplied externally via serial port 1 or internally via the modem on
connector.
When Enabled is set the system can be switched on by means of an incoming message.
When Disabled is set the system cannot be switched on by means of an incoming message.
Magic Packet
determines whether the system can be switched on by means of an LAN controller (onboard or
additional board).
When Enabled is set the system can be switched on by means of an LAN controller.
When Disabled is set the system cannot be switched on by means of an LAN controller.
22 - English
Page 1/1
.............. [30] Minute(s)
.................... [Suspend ]
..... [Off] Minute(s)
[Enabled ]
F1 = Help
→ ← = Change Setting,
A26361-K522-Z120-2-7419
Advertisement
Table of Contents
