Advertisement
Do not erect ladder on heavily
FIGURE 2C.
contaminated ground.
Ladders with steps/rungs should be used
FIGURE 2D.
so that the steps/rungs are in a level, horizontal position.
Safety Step Platforms
Ensure the platform deck has fully engaged
FIGURE 2E.
the rung when lowering deck into position.
Extension & Single Ladders
Do not use the ladder as a bridge.
■
Secure the top and/or bottom of the ladder if possible.
■
Ensure top of the ladder makes contact with a structure
■
that is in good condition.
Fall Control System
Secure the ladder to a ground or wall fixing.
■
To ensure correct angle, use the angle
FIGURE 2F.
indicator marked on the rail and/or the level-bubble in
the TerrainMaster base.
Ladders used for access to a higher level
FIGURE 2G.
shall be extended at least 1 metre above the landing
point and secured if necessary.
Only use the ladder in the direction indicated.
FIGURE 2H.
Do not lean the ladder against unsuitable
FIGURE 2I.
surfaces. For pole work use a Branach Pole Strap or
Pole Chain combined with a Top Lash.
Do not stand on the top 3 steps/rungs of
FIGURE 2J.
a leaning ladder.
Ensure the latch has fully engaged the rung
FIGURES 2K.
when extending the ladder. If the latch is not parallel with
the ladder, adjust so it is engaged fully.
TerrainMaster
Always use with TerrainMaster feet in an open position.
■
Do not exceed the level the TerrainMaster can
FIGURE 2L.
operate in (15° slope). Use the built-in level bubble or spirit
level to ensure the platform ladder steps are level.
(FED-FC)
05
Advertisement
