Advertisement
Complete Descender Roping
Slide thumb catch with arrows to right hand side.
1
Unlatch yellow release lever.
2
Turn cover clockwise to expose rope entry slot.
3
Create 20cm of slack in the rope line, then insert rope
4
into slot using thumb.
Turn cover plate clockwise until rope is aligned with
5
the lower rope exit slot.
Pull down on rope to make sure it exits the descender.
6
Turn cover plate anti-clockwise back to the
7
locked position.
Check that cover cannot rotate and has locked.
8
Pull down on rope from below the descender to
9
remove slack from life-line.
1
4
7
Tether Setup
Select anchor point: soft ground screw, masonry anchor,
pole. Pole attachment: attach ladder tethers around pole
or onto structure. Ground or masonry attachment: drill
into surface, insert ground screw or masonry anchor.
Release tether lever on rear side of ladder and
1
pull rope out.
Un-clip tether hook from housing.
2
Un-hook tether from lower hook point.
3
18
2
5
8
3
6
9
Advertisement
