Community Playthings The Community Loft 1 Corner Lof Product Manual page 8

5
Check the joints. Every panel should be
locked in place by four connector rings.
Repeat this step for each panel as you
build your loft.
7
Slide another connector ring flat side
down onto each post.
8
6
To add the next panel, lift one of the
connector rings and use it to capture the
new panel. Assemble the first layer of your
loft by following the configuration (see
page 10). Go slowly; it is not easy to replace
a panel after a layer is placed on top.
8
Lay platforms in place. Add the stairs. All
four corners of each stair should fit into
connector rings.
The Community Loft