Sdd Square Fold Booklet-Maker With Two-Knife Trimmer - Canon varioPRINT 135 Customer Expectation Document

6.17 SDD Square Fold Booklet-Maker with Two-Knife Trimmer

Item
Input Accessory
Pass Through Width
(No Trimming)
Booklet Trimming
Acceptable Paper
Weights
Trimming Width
Asymmetrical Trim
(Offset Capability)
Minimal Booklet Staple
Clearance (from Top to
Bottom)
Booklet Sheet Capacity
Maximum Productivity
Power Source
Maximum Power
Consumption
Dimensions (H x W x D)
Weight
39 If a booklet's input height is greater than 12.60" (320 mm), it must be trimmed to 12.60" (320 mm) or fewer
inches (millimeters).
Version 13
Booklet Trimmer-D1 is required.
Approximately 8.27" (210 mm) to 12.60" (320 mm)
39
Input Width :
Output Width:
Input/Output Length:
16 lb bond to 110 lb cover (60 to 300 g/m
Each Side: 0.08" to 1.38" (2 mm to 35 mm)
Together: 0.16" to 2.76" (4 mm to 70 mm)
Approximately ±0.59" (15 mm)
Approximately 1.57" (40 mm)
Up to 25 sheets (100 pages per booklet or 5 mm in height, whichever is less)
(20 lb bond (80 g/m
Up to 800 booklets/hour (each booklet up to 100 pages)
(20 lb bond (80 g/m
120 V AC, 60 Hz, 15 A
Approximately 740 W
Approximately 51.2" x 62.7" x 27.6" (1,300 mm x 1,592 mm x 700 mm)
(with the conveyor tray fully extended)
Approximately 573 lb (260 kg)
varioPRINT 135 Customer Expectations Document
varioPRINT 135 Customer Expectations Document
Specifications
Approximately 8.27" (210 mm) to 12.60" (320 mm)
Approximately 7.87" (200 mm) to 12.60" (320 mm)
Approximately 4.71" (120 mm) to 9.60" (244 mm)
2
)
2
))
2
))
Page 46