Front Turn Signal And Parking Lamps - Buick 2003 Century Owner's Manual

5. Remove the rubber access cover from behind the
bulb you are replacing.
6. Turn the bulb socket one-quarter turn and remove it
7. Lift the plastic locking tab on the electrical connector
from the headlamp assembly.
and pull the connector from the headlamp bulb
socket.
9. Insert the bulb socket into the headlamp assembly.
IO.
Reverse all steps to reassemble the headlamp
assembly, then check the lamps.
Front Turn Signal and Parking
Lamps
1. Remove the headlamp assembly. Refer to the
removal procedure earlier in this section.
2. Remove the rubber bulb access cover.
3. Twist the sidemarker lamp socket, located on the
outboard side of the headlamp assembly,
counterclockwise and pull it from the headlamp
assembly.
4. Holding the base of the socket, pull the old bulb
from the socket.
5. Push the new bulb into the socket.
6. Reverse Steps 1 through 3 to reinstall the lamp
assem bly.
8. Connect the new headlamp bulb to the electrical
connector, making sure the connector tab snaps
into place.
5-52