Table of Contents
Advertisement
Available languages
Available languages
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
A permanently high power level can lead to increa-
sed ice formation. In this case, the appliance can be
defrosted manually →
power level.
Changing the bulb
CAUTION:
Do NOT remove the cover of the interior light.
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.
Troubleshooting
Before you contact an authorized specialist
Problem
Cause / Action
Unit is not
∙ Check the power supply / tem-
working
perature setting / ambient temper-
properly or
ature. ∙ Unblock the ventilation
at all
openings, install the unit freely.
Loading is
∙ Check the temperature setting /
too warm
ambient temperature. ∙ Open the
door only as long as necessary.
Loud noise
∙ Check the appliance position.
during opera-
∙ See the section "Operating
tion
noise".
Water on the
∙ Check the temperature setting /
unit bottom
water discharge channel or open-
ing.
Light does
∙ Check the power supply.
not work
∙ See "Changing the bulb".
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
Recommendation:
set a lower
Technical Data
Climate class N/ST/T: this appliance is intended to
be used at ambient temperature ranging from 16°C
to 43°C.
Electrical connection............................................
Power voltage: .........................220-240 V~ / 50 Hz
Rated power: ...............................................70 W
Rated current: ..............................................0.5 A
Dimension H x W x D / Weight...............................
Appliance size: ....................169.0 x 55.8 x 59.0 cm
Net weight: ..................................approx. 51.0 kg
For more information about the product, scan the QR
code on the supplied energy label and/or visit the
official website of the product data bank:
https://eprel.ec.europa.eu
The right to make technical and design modifications
during continuous product development remains
reserved.
This appliance has been tested according to all rele-
vant current CE guidelines, such as electromagnetic
compatibility and low voltage directives, and has
been constructed in accordance with the latest safety
regulations.
23
Advertisement
Table of Contents
