Headlight High-Low Beam Changer; Windshield Wipermasher - Buick 1993 LeSabre Owner's Manual

some jurisdictions
may
require that
you
operate your
lower beam lamps with fog lamps at all times, or that
headlamps be turned on whenever you must use your
windshield wipers.
In
addition, most jurisdictions
prohibit driving solely with parking lamps, especially at
dawn or dusk. It is recommended that
you
check with
you own State or Provincial highway authority for
applicable lighting regulations.
Headlight High-Low Beam
'
To change the headlights
from low beam to high or
high to low, pull the turn
signal lever all the way
toward you. Then release it.
When the high beams are
on, this blue light on the
instrument panel also will
be on.
Windshield Wipers
. . .
,rll
You control the windshield wipers by turning the band
marked "WIPER."
For a single wiping cycle, turn the band to "MIST."
Hold it there until the wipers start, then let go. The
wipers will stop after one cycle. If you want more
cycles, hold the band on "MIST" longer.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain or
snow. Turn the band to choose the delay time. The
closer to "LO," the shorter the delay.
87