Replacing The Lamp; Troubleshooting - Zanussi ZCI66280WA User Manual

REMOVING AND CLEANING THE DOOR
GLASSES - MAIN OVEN
The door glass in your product can be
different in type and shape from the
example you see in the image. The
number of glasses can also be
different.
1. Push the door trim at one side to remove it.
2
1

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
You cannot activate or operate
the hob.
You cannot activate or operate
the hob.
A
Possible cause
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
The fuse is blown.
You touched 2 or more sensor
fields at the same time.
There is water or fat stains on
the control panel.
2. Pull up the trim.
3. Remove the glass panels.
To replace the glass panels, do the
same steps in reverse. Before you
lower the trim, attach the A trim part to
the door. Refer to the image.

REPLACING THE LAMP

WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven is cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
The lamp glass cover is at the back of
the cavity.
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300 °C
heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Touch only one sensor field.
Clean the control panel.
Remedy
27