TABLE OF CONTENTS Safety Information ....................................3 Installation and Operation ..................................4 Wiring Diagrams ....................................... 6 Repair Parts Index ....................................9 Troubleshooting ......................................15 Warranty ........................................16 NOTE! To the installer: Please make sure you provide this manual to the owner of the equipment or to the responsible party who maintains the system.
SAFETY INFORMATION READ AND FOLLOW SAFETY INSTRUCTIONS! PUMPS Pump builds up heat and pressure during operation; allow This is the safety alert symbol. When you see this symbol time for pump to cool before handling or servicing. on your pump or in this manual, look for one of the following Only qualified personnel should install, operate or repair ...
INSTALLATION AND OPERATION HAZARDOUS LOCATION SERVICE PUMP MODELS These pumps are to be used for handling sewage, wastewater These instructions cover the installation and service of the and storm water only. Do not use in other hazardous locations. Myers pumps as listed on the front cover. The hazardous These motors must be repaired and serviced only at Myers location models are Factory Mutual approved and listed Authorized Service Centers or at the Myers factory.
Page 5
INSTALLATION AND OPERATIONS The presence of water energizes a red seal leak warning light ELECTRICAL MOTOR CONTROLS at the control panel. This is a warning light only, and does not All electrical controls and motor equipment should be as stop the motor. It indicates a leak has occurred and the pump specified in these instructions.
Page 6
INSTALLATION AND OPERATIONS PUMP REASSEMBLY The fluid end of the pump is field serviceable and can be Remove the ceramic portion of the new seal from the disassembled in case of wear, damage, plugging or outboard package. Brush new dielectric oil around the rubber portion seal failure.
Page 10
REPAIR PARTS INDEX 3450 RPM 20 HP 20 HP 20 HP 25 HP 25 HP 25 HP 30 HP 30 HP ITEM DESCRIPTION 230/3/3450 460/3/3450 575/3/3450 230/3/3450 460/3/3450 575/3/3450 230/3/3450 460/3/3450 ROTOR; W/SHAFT – ORDINARY 26576D312 26576D312 26576D312 26576D312 26576D312 26576D312 26576D312 26576D312...
Page 11
REPAIR PARTS INDEX 1750 RPM 30 HP 30 HP 30 HP 30 HP 40 HP 40 HP ITEM DESCRIPTION 200/3/1750 230/3/1750 460/3/1750 575/3/1750 230/3/1750 460/3/1750 ROTOR; W/SHAFT – ORDINARY LOCATION 26576D310 26576D310 26576D310 26576D310 26576D310 26576D310 ROTOR; W/SHAFT – HAZARDOUS LOCATION 26576D310X 26576D310X 26576D310X...
Page 12
REPAIR PARTS INDEX 1150 RPM 10 HP 10 HP 15 HP 15 HP 15 HP Item Description 460/3/1150 575/3/1150 200/3/1150 230/3/1150 460/3/1150 ROTOR; W/SHAFT – ORDINARY LOCATION 26576D306 26576D306 26576D306 26576D306 26576D306 ROTOR; W/SHAFT – HAZARDOUS LOCATION 26576D306X 26576D306X 26576D306X 26576D306X 26576D306X HOUSING, BRG;...
TROUBLESHOOTING CHECKING FOR MOISTURE IN MOTOR RESISTANCE OF WINDINGS Use an ohm - meter or a megger and set on highest scale. Every motor winding has a fixed resistance. The windings must Readings on the large power cord between any of the check close to specification values.
Ph: 800-363-PUMP WWW.FEMYERS.CoM All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners. Because we are Warranty Rev. 12/13 continuously improving our products and services, Pentair reserves the right to change specifications without prior notice. Pentair is an equal opportunity employer.