Related Manuals for Emerson 500 Series
Summary of Contents for Emerson 500 Series
- Page 1 500 Series 570/560 Surge Protective Device Installation, Operation and Maintenance Manual Courtesy of NationalSwitchgear.com...
-
Page 2: Table Of Contents
EMERSON NETWORK POWER SURGE PROTECTIVE DEVICE INSTALLATION, OPERATION AND MAINTENANCE MANUAL TABLE OF CONTENTS UNPACKING AND INSTALLATION Unpacking and Preliminary Inspection ................2 Handling Considerations ....................2 Storage ..........................2 LOCATION CONSIDERATIONS Environment ........................2 Audible Noise ........................2 Service Clearances ......................2 Mounting ........................ -
Page 3: Unpacking And Installation
Audible Noise — The audible noise of the shipping agency and forward a copy to your unit is less than 40 dB at 5 feet, which allows local Emerson Network Power Surge its placement within almost any room if Protection Sales Representative. -
Page 4: Model Number Configuration
Warning: Indicate[s] a Caution: Indicate[s] a hazardous situation which, if not avoided, hazardous situation which, if not avoided, could result in death or serious injury. could result in minor or moderate injury. WARNING [signs] should not be used for CAUTION [signs] without a safety alert property damage hazards unless personal symbol may be used to alert against... - Page 5 Installation, Operation and Maintenance Manual IO-70100 Rev 3 7-15 Courtesy of NationalSwitchgear.com...
-
Page 6: Electrical Connections
ELECTRICAL CONNECTIONS All wiring must comply with the National Electrical Code (NEC) and applicable local NEC 285.21 Connections codes. NEC 285.23 Type 1 SPD’s. Shall be installed in accordance with 285.35(A) and (B). DANGER! ONLY (A) Installation. Type 1 SPD’s shall be QUALIFIED PERSONNEL SHOULD INSTALL installed as follows: OR SERVICE THIS SYSTEM. -
Page 7: Grounding Electrode
An insulated grounding conductor is required Grounding Electrode — Surge protective in addition to any metallic raceway, which may devices do not discharge all surges to ground be used as a grounding conductor. For (earth). Surge protective devices can also parallel-connected SPDs, the grounding divert the surge current back to its source to conductor should be the same wire size as... -
Page 8: Installation Instructions
INSTALLATION INSTRUCTIONS The Emerson Network Power 570/560 Series extinguished or a RED LED is illuminated, Surge Protective Devices (SPDs) are high check to ensure that power is applied to the quality, high energy surge current diversion SPD. If an abnormal indication is present,... -
Page 9: Suggested Circuit Breaker And Wire Size (Chart)
SUGGESTED CIRCUIT BREAKER AND WIRE SIZE (For Motorola R56 Approved models, see page 9) Allowable Range Factory Suggested Size Surge Rating Connection Wire Size Circuit Breaker Size Connection Wire Circuit Breaker Per Mode With With With With Size Size Compression Compression Disconnect Disconnect... -
Page 10: Suggested Circuit Breaker And Wire Size (Motorola R56 Approved Models)
Motorola R56 Approved Models SUGGESTED CIRCUIT BREAKER AND WIRE SIZE Overcurrent Protection (Circuit Breaker): Allowable Range: 15A — 175A ..............Suggested Size: 80A Connection Wire: Allowable Range: #14 - 2/O ............... Suggested Size: #4 DIMENSIONAL INFORMATION Model Number R56 Type Weight 570SA16FNRJ1S Type 1 (MOV/SAD Hybrid) -
Page 11: Monitoring Features
Servicing restore the system to normal operation. An The Emerson Network Power 570/560 Series audible alarm disable is provided to silence comes with a ten year parts and five year the alarm. The system will automatically reset labor warranty. -
Page 12: Corrective Maintenance
800 288 6169 Phone (U.S. & Canada Only) 607 721 8840 (Outside U.S.) © 2014 Emerson Network Power. All rights reserved throughout 607 722 8713 FAX the world. Specifications subject to change without notice.