Table of Contents
Advertisement
SFM2
Solid Structure Installation
1. Use the four mounting points on the back plate (Figure 2).
2. Choose the wall where the monitor will be located.
3. Level and mark with a pencil the four (4) mounting points found on the back plate.
4. Drill four (4) 1/4" pilot holes for the plastic anchors then secure the wall bracket with the four (4) #10 x
1¼" screws (supplied) to the anchors.
NOTE:
All electrical wiring should be done at this time. Use the two (2) 6/32" x 1" handy box screws
(supplied) for your installation needs.
#10 Wood
Screws
Electrical
Opening
#10 Wood
Screws
Page - 6 -
Figure 2
Solid
Structure
#10 Wood
Screws
Frontplate
#10 Wood
Screws
Installation Manual
Advertisement
Table of Contents
