SFM2
Attaching the Display to the Backplate
NOTE:
For clarity purposes, the following illustrations will be shown without the adapter plate and display
attached. This must be done to show how the positioning of the backplate cover and the backplate
relate to each other (connection-wise).
1. The flange opening must be facing up.
2. Raise the flat panel with the front plate attached and slide the top flange opening to the flange on the
backplate (Figure 7).
3. Slide the monitor down slowly. Make sure the backplate flange captures the frontplate top flange opening
before letting go of the monitor. Slide down and push in (Figure 8).
4. To secure the two plates, tighten the two (2) M6 x 12 (mm) security screws using a long Phillip head
screwdriver (Figure 9).
Flange Opening
(Slot opening
on top of
frontplate)
Frontplate
Page - 10 -
Figure 8
Figure 7
Simulated Display
Flange
Backplate
M6 x 12mm
Security Screws
Figure 9
Installation Manual