Adjustment Function Details; Date And Time Functions; User Interface Functions - Fujitsu WATERSTAGE WOYG160LJL Maintenance Document

►

Adjustment Function Details

▼ Date and Time Functions

The controller has an annual clock which contains the
time, the day of the week and the date.
In order for the function to operate, the time and date
must be set properly on the clock.
Line Nr Programming line
1 Hour/minutes
2 Day/month
3 Year
5 Start of summertime
6 End of summertime
Note: Summer time/winter time change.
Dates have been set for changing to summer time or
to winter time. The time changes automatically from
2am (winter time) to 3am (summer time) or from 3am
(summer time) to 2am (winter time) on the fi rst Sunday
following the respective date.
Waterstage / Maintenance Manual / 2105 - EN

▼ User Interface Functions

Line Nr Programming line
20 Language
22 Info
26 Operation lock
27 Programming lock
28 Direct adjustment...
29 Temperature unit
Pressure unit
I
nfo (22)
• Temporary
After pressing the Info key, the information display
returns to the basic "predefi ned" display after 8 minutes
or when pressing the operating mode key.
• Permanent
After pressing the Info key, the information display
returns to the "new" standard display after a maximum
of 8 minutes. The last selected information value is
shown in the new basic display.
Operation lock (26)
If the operating lock is activated, the following control
elements can no longer be adjusted:
- Heating circuit mode, DHW mode, room temp comfort
setpoint (knob), occupancy key.
Programming lock (27)
If the programming lock is activated, the setting values
are displayed but may no longer be changed.
• Temporary Suspension of Programming
The programming lock can be temporarily deactivated at
programming level. To do this, simultaneously press the
OK and ESC keys for at least 3 seconds. The temporary
suspension of the programming lock remains in eff ect
until you exit the programming.
• Permanent Suspension of Programming
First perform a temporary suspension, then cancel
"Programming lock" on line 27.
Direct adjustment... (28)
• Automatic storage
Correction of the setpoint with the knob is adopted
without a particular confi rmation (timeout) or by pressing
the OK key.
• Storage with confi rmation
Correction of the setpoint with the knob will be adopted
only after pressing the OK key.
- 65 -