Setup 5: Connect The Power Cord; Setup 6: Secure The Cords And Close The Connector Cover; Setup 7: Turn On The Display And Computer - Sony SDM-X75FB Operating Instructions (English starts on page 25) Operating Instructions Manual

Setup 5: Connect the power cord

1
Connect the supplied power cord securely to the
display's AC IN connector.
2
Connect the other end securely to a power outlet.
2 to a power outlet
power cord (supplied)
Setup 6: Secure the cords and
close the connector cover
1
Draw the cords and cables through the cable holder
as illustrated.
2
Close the connector cover.
Note
When bounding the cords and cables, be sure to loosen them a little. If
they get pulled hard they may come off from the connectors/plugs as you
adjust the screen angle. If you stretch the cords and cables too hard they
may get damaged.
1
to AC IN
Setup 7: Turn on the display and
computer
1
Make sure that the 1 (power) Indicator blinks red. At
the time of your purchase, the MAIN POWER switch
is set to the \ side.
Note
When the MAIN POWER switch on the right side of your display is not
set to the \ side, press the \ side and check that the 1 (power) indicator
blinks red.
2
Press the 1 (power) switch located on the front
right of the display.
The 1 (power) indicator lights up in green.
3
Turn on the computer.
10
lights in red
MAIN POWER
lights in green