Download Print this page

Troubleshooting; On-Screen Messages - Sony SDM-S205FB Operating Instructions Manual

20" flat panel lcd computer display
Hide thumbs Also See for SDM-S205FB:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 27

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see "Trouble symptoms and remedies" on page 20.
If "OUT OF RANGE" appears on the screen
This indicates the input signal is not supported by the display's
specifications. Check the following items.
For more information about on-screen messages, see "Trouble
symptoms and remedies" on page 20.
If "xxx.x kHz/xxx Hz" is displayed
This indicates either the horizontal or vertical frequency is not
supported by the display's specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.
Example
I NFORMA T I ON
OUT OF RANGE
I NPUT 1 DV I - D
:
x x x . x k H z /
If "RESOLUTION > 1600 × 1200" is displayed
This indicates that the resolution is not supported by the
display's specifications (1600 × 1200 or less).
Example
I NFORMA T I ON
OUT OF RANGE
I NPUT 1 : DV I - D
RESOL UT I ON >
x x x H z
1 0 0 X 1
6
2
0
0
If "NO INPUT SIGNAL" appears on the screen
This indicates that no signal is being input via the currently
selected connector.
When INPUT SENSING (page 16) is set to ON, the display finds
another input signal and changes the input automatically.
Example
I NFORMA T I ON
NO I NPUT S I GNA L
I NPUT 1 DV I - D
GO TO POWER SAVE
When input signals cannot be found,
"GO TO POWER SAVE"
message appears. About 5 seconds later, the power saving
mode starts.
If "CABLE DISCONNECTED" appears on the
screen
This indicates that the video signal cable has been disconnected
from the currently selected connector.
When INPUT SENSING (page 16) is set to ON, the display finds
another input signal and changes the input automatically.
Example
I NFORMA T I ON
CAB L E D I SCONNECT ED
I NPUT 1 DV I - D
GO TO POWER SAVE
When input signals cannot be found,
"GO TO POWER SAVE"
message appears. About 45 seconds later, the power saving
mode starts.
19
:
:
GB

Advertisement

loading

This manual is also suitable for:

Sdm-s205kSdm-s205 series