Advertisement
7100SB, 7100DB, MSK-755 WITH POSITIONING MOTOR USER'S BULLETIN
1
TIME USERS OF BLINDSTITCH MACHINES – PLEASE READ CAREFULLY
ST
If you have never used a blindstitch machine before, it is very important that you read these
instructions carefully.
Failure to read may limit or void the manufacturer's warranty.
Instructions:
Activate the knee lifter. This will causes the feed plate/frame to swing downward and create a
•
gap between the presser foot and the feed plate.
Insert the work into the gap in such a manner that the folded or sewn edge of the material is
•
alongside the edge guide of the presser foot.
When the material is in the proper position, completely release the knee lifter. Run the
•
machine slowly and watch the material pass the edge guide.
When you're done with the seam, to remove the work from the machine, heel back on the
•
treadle to set the looper in the forward position. (see image below).
Note:
Activate the knee lifter, this will cause the feed plate/frame to swing downward and create a
•
gap between the presser foot and the feed plate.
Pull the work-piece straight back with a quick stroke. This will lock the last stitch and break
•
the thread.
To start another seam repeat the first three points.
•
Notes:
The needle must be in 100% good condition at all times, no nicks, blunt point, or bent needle will
work.
When sewing flat seams make sure the work-piece is in deep under the presser foot to allow the
needle to penetrate on the first stitch of sewing.
TO REMOVE THE WORK PIECE THE LOOPER MUST BE IN THIS POSITION AS ILLUSTRATED
LOOPER IN TOP
FORWARD
POSITION
Advertisement
