Advertisement
nd
2
step:
1. Fix the wheel frame construction on either side of the driving axle and connecting rod.
2. Insert two M6×40 screws through the wheel frame into the connecting rod. Make sure that the
hole on the driving axle is on the right as shown.
3. Fix the mounting frame and foot to the hopper with M6×40 screws, M6 counter nuts and big
washers ⌀6.
Note: The screws and nuts do not need to be tightened yet.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 60910
Page 5
06
2021-1
Advertisement
